NOVOTEST UT-3A-EMA Ultrasonic Thickness Gauge

NOVOTEST UT-3A-EMA is designed to measure thickness of objects, such as pipes, tanks, sheet products, ship bottoms  and other parts, made of metals and alloys, without application of couplant and advance surface preparation, through air gap or a layer of rust, dirt, salt or other non-conductive coatings (paint, varnish, enamel, plastic, etc.) up to 6 mm. Also it is used for evaluation of anisotropy degree of the material. Pulsed electro – magnetic technology implemented in the EMA transducers allows user to put the probe not exact perpendiculary to the surface, but up to 25 degrees of skew and get correct readings.

Advantage:
Thickness measurement (steel) – 2…60 mm
Convenience and easy in operation
Probe type selection
Preset velocity of ultrasound (1000 – 9999m/s) with 1 m/s step
Without application of couplant and advance surface preparation, through air gap or a layer of rust, dirt, salt or other non-conductive coatings (paint,varnish, enamel, plastic, etc.) up to 6 mm
Allows user to put the probe not exact perpendiculary to the surface, but up to 25 degrees
Acoustic contact indication on the graphic display
Fixation of the last measurement result in the removal of the transducer surface
Power supplied by standard AA batteries
Shock-resistant housing with a protective silicone bumper-case
The device has a bright contrast LCD display
A-scan, B-scan, calibration settings

Three thickness measurement modes:
Automatic
Manual mode, measurements are made using maximum in the first gate
Manual mode, measurements are made using two maximums in two gates

Complette Package:
Electronic unit Ultrasonic Thickness Gauge
Transducer (probe) – 1 pc (depends on the desired range of controlled thickness
Charger
Cables
Calibration certificate
Operating manual
Case