- Air Quality Meter
- Anemometer
- Battery Test Analyzer
- Calibration Tester
- Chart Data Recorder
- Chlorine Meter
- Clamp Meter
- Coating Thickness
- Concrete Meter
- Conductivity Meter
- Current Injection Test
- Current-Echosounder
- Deadweight Tester
- Density Meter
- Dew Point Hygrometer
- Dissolved Oxygen
- Fault Finder Locator
- Flaw Detector
- Flow Meter
- Force Gauge
- Gas Analyzer
- Gauss Meter
- Grain Moisture
- Ground Resistance
- Hand Pump
- Hardness Tester
- High Voltage Rercue
- Hipot Tester
- Holiday Detector
- Insulation Tester
- Leak Detection
- Level Lube Controller
- Light Meter
- Manometer
- Multimeter
- Networks Analyzer
- Ohm Meter
- Oil Content Analyzer
- Oscilloscopes
- Other Products
- PH Meter
- Pipe Cable Locator
- Power Quality Analyzer
- Pressure Gauge
- Rangefinder
- Shaft Alignment
- Sound Level Meter
- Spectrophotometer
- Stroboscope
- Tachometer
- Temp. Calibrator
- Thermal Imager
- Thermohygrometer
- Thermometer
- Torque Tester
- Turbidity Meter
- Ultrasonic Thickness
- Vibration Analyzer
- Video Borescope
- Water Level Meter
- Water Quality Meter
- Weather Station
- Wood Moisture Meter
MURPHY MTH6 Digital Tachometer and Hourmeter
Harga dapat berubah sewaktu-waktu mengikuti perkembangan kurs rupiah terhadap mata uang asing lainnya sehingga sangat mungkin terjadi adanya perbedaan harga yang berlaku dengan harga yang tertera pada website kami.
The MTH6-1 is a microprocessor-based digital tachometer and hourmeter with a built-in overspeed shutdown or alarm switch. It measures speed and running hours and can give an alarm or shut down the engine on overspeed.
The MTH6-1 case is polycarbonate, and its dial measures 3-1/2 in. (89 mm) in diameter. RPM data for the tachometer and overspeed switch is supplied by a magnetic pickup or battery charging alternator. It's 5-digit, liquid crystal display is updated every second.
The magnetic pickup is installed into the flywheel housing of an internal combustion engine. The starter ring gear acts upon the magnetic pickup to generate a voltage pulse each time a gear tooth passes the end of the sensor. This makes calibration simple - just enter the number of pulses per engine revolution and the overspeed set point value using the membrane switches located on the front of the unit.
MTH61 digital tachometer and hourmeter by Murphy.
White background face plate
Bright stainless steel bezel
3-1/2 Inches (89 mm) diameter dial
Powered by 8 to40 VDC
Large 5-Digit LCD display
Reads RPM data from a magnetic pickup or battery charging alternator