- Air Quality Meter
- Anemometer
- Battery Test & Analyzer
- Calibration Tester
- Chart Data Recorder
- Chlorine Meter
- Clamp Meter
- Coating Thickness
- Concrete Meter
- Conductivity Meter
- Current & Echosounder
- Current Injection Test
- Deadweight Tester
- Density Meter
- Dew Point Hygrometer
- Dissolved Oxygen
- Fault Finder Locator
- Flaw Detector
- Flow Meter
- Force Gauge
- Gas Analyzer
- Gauss Meter
- Grain Moisture
- Ground Resistance
- Hand Pump
- Hardness Tester
- High Voltage Rercue
- Hipot Tester
- Holiday Detector
- Insulation Tester
- Leak Detection
- Level Lube Controller
- Light Meter
- Manometer
- Multimeter
- Networks Analyzer
- Ohm Meter
- Oil Content Analyzer
- Oscilloscopes
- Other Products
- PH Meter
- Pipe Cable Locator
- Power Quality Analyzer
- Power Supply
- Pressure Gauge
- Rangefinder
- Shaft Alignment
- Sound Level Meter
- Spectrophotometer
- Stroboscope
- Tachometer
- Temp. Calibrator
- Thermal Imager
- Thermohygrometer
- Thermometer
- Torque Tester
- Turbidity Meter
- Ultrasonic Thickness
- Vibration Analyzer
- Video Borescope
- Water Level Meter
- Water Quality Meter
- Weather Station
- Wood Moisture Meter
FINA DC-2000-BP Baled Paper Moisture Meter
Harga dapat berubah sewaktu-waktu mengikuti perkembangan kurs rupiah terhadap mata uang asing lainnya sehingga sangat mungkin terjadi adanya perbedaan harga yang berlaku dengan harga yang tertera pada website kami.
The Model DC-2000-BP baled paper moisture meter is calibrated to test the moisture content in bales of scrap paper materials. This easy to operate instrument can be used in factories, mills and yards.
The DC-2000-BP operates by means of a circuit that measures DC resistance in the range of 100,000 megohms to .02 megohms. Using the Electrode Probe, the actual moisture reading occurs across the insulated portion of the probe, which is located one inch from the tip. Thus the probe can be pushed through a wet surface to give an accurate reading of the moisture below, at any depth or successive depth. The 1/4” (6.4 MM) diameter probe is 5” (12.7 cm) long with a rounded-point tip for easy, safe insertion and is constructed of stainless steel, Teflon® & Delrin® plastics for highest quality insulation and freedom from corrosion.
Features
Auto-Ranging Digital Display reads in the 5 to 25 percent moisture content range.
Microprocessor based with large LCD display for easy reading.
Pocket size and weighs less the one pound.
Complete with 9 volt Battery, Manual, Probe, and Carrying Case.
Calibration Standard available separately.