AMS DS1200-AMT Online Dewpoint Hygrometer

The Online Dewpoint Hygrometer DS1200-AMT, manufactured, calibrated and supplied by Alpha Moisture Systems, UK, is distributed throughout Australia by KD Instruments. 
DS1200-AMT is a display-controller and dew-point transmitter combined to make an easily installed, reliable and accurate dew point hygrometer. 
The transmitter can be configured at the factory to the users' specified unit of measure, e.g. in either ºC, ºF, ppm(v), ppm(w), g/m3, or lb/MMSCF. 
The DS1200 display controller can be panel mounted considerable distances from the Model AMT transmitter. 
Any additional accessories, such as a dewpoint transmitter holder (sample cell), fittings or cabling are all available through KD Instruments. 

Features:
Rapid Response
Display in C, F Dewpoint, ppmv,ppbv & lbs/MMSCF
Accuracy to +/- 2 degrees C Dewpoint
Built in AUTO CAL procedure
NEMA IP66
metric and non metric units
Linear analog output 4 - 20 mA
Two relay alarms
Universal Power supply 24-230VAC
Traceable Calibration
UL 508

Specification of DS1200 Dewpoint Hygrometer
Model    DS1200
Panel meter/system
Ranges    
HD -65°C to +20 °C dewpoint. (-85°F to    +68 °F)
SD -100°C to +20°C dewpoint. (-148°F to    +68 °F)
LD -120°C to +20°C dewpoint. (-184°F to    +68 °F)
Display    4 digit 14 segment bright red LED 0.5"
Resolution    0.1 degsC, 0.1 degs F dewpoint or 0.1ppm (v)
Alarm relays    2 sets of voltage free changeover alarm contacts rated at 7A@240 VAC, 7A@30VDC
Set points adjusted from the front panel
Analog Output    Isolated 4 - 20 mA, max load 800 Ohms
Power Supply    
24 - 250 VAC 3.5W, 50/60Hz universal power adaptor. Or
20 - 300 VDC / 150 - 15 mA

Panel Meter Housing    1/8 Din IP66 front panel.
Cutout dimensions 92 x 45 mm
Sensor
Sensor type    Aluminum Oxide Ultra High Capacitance patented Alpha Systems Dewsmart.
Sensor Accuracy    +/- 2 degs C dewpoint
Repeatability    better than +/- 3°C dewpoint
Pressure    From 0.15 PSIA (0.01 barA) to Maximum 5,075 PSIA ( 350 barA)
Sample Flow    Flow independent, ideally 4 to 10 SCFH (2 to 5 LPM). Max: 50 SCFH.
Case material    Stainless steel IP 65 weatherproof
Connector    8 pin
Cable    4 wire shielded up to 100 m length
Sensor Holder     
Material    Stainless Steel
Connections    1/4 inch Swagelock tube fittings
Mountings    2 x M5 tapped holes in base or 
4 holes 5 mm diameter @ 42 x 35 centers in mounting bracket
System
Warm up time    10 seconds
Operating conditions    -20 to +60 °C (-4°F to 140°F)
10 - 90 % RH non condensing
Storage temperature    -20 to +70°C (-4°F to 158°F)
Electromagnetic    Emission & Immunity: Complies with EN 61326
LVD 73/23/EEC: Complies with EN 61010-1