- Air Quality Meter
- Anemometer
- Battery Test Analyzer
- Calibration Tester
- Chart Data Recorder
- Chlorine Meter
- Clamp Meter
- Coating Thickness
- Concrete Meter
- Conductivity Meter
- Current Injection Test
- Current-Echosounder
- Deadweight Tester
- Density Meter
- Dew Point Hygrometer
- Dissolved Oxygen
- Fault Finder Locator
- Flaw Detector
- Flow Meter
- Force Gauge
- Gas Analyzer
- Gauss Meter
- Grain Moisture
- Ground Resistance
- Hand Pump
- Hardness Tester
- High Voltage Rercue
- Hipot Tester
- Holiday Detector
- Insulation Tester
- Leak Detection
- Level Lube Controller
- Light Meter
- Manometer
- Multimeter
- Networks Analyzer
- Ohm Meter
- Oil Content Analyzer
- Oscilloscopes
- Other Products
- PH Meter
- Pipe Cable Locator
- Power Quality Analyzer
- Pressure Gauge
- Rangefinder
- Shaft Alignment
- Sound Level Meter
- Spectrophotometer
- Stroboscope
- Tachometer
- Temp. Calibrator
- Thermal Imager
- Thermohygrometer
- Thermometer
- Torque Tester
- Turbidity Meter
- Ultrasonic Thickness
- Vibration Analyzer
- Video Borescope
- Water Level Meter
- Water Quality Meter
- Weather Station
- Wood Moisture Meter
TIME ELECTRONICS 1077 Milliamp Transducer Simulator
Harga dapat berubah sewaktu-waktu mengikuti perkembangan kurs rupiah terhadap mata uang asing lainnya sehingga sangat mungkin terjadi adanya perbedaan harga yang berlaku dengan harga yang tertera pada website kami.
Features:
3 operating modes
Accuracy 0.02%
100mA source and load
24V line mode
Variable drive source 14 to 40V
Safety terminals
Removable protective cover
Supplied with rechargeable batteries
10 hours typical use between charges
The Time 1077 contains 3 three modes: an adjustable current load for the simulation of a transducer on a line, an adjustable power supply mode from 14V to 40V and a precision current sourcing mode from 14 to 40V drive capacity.
This transducer simulation device is primarily used for the testing and simulation of milliamp transducer systems both inside laboratories and when out in the field. To accommodate for tests outside the lab the 1077 is encased in protective rubber and is designed to resist common stresses such as those found in process control applications. It's also portable enough to be used in just one hand and won't require a desktop for comfortable use and it runs on rechargeable batteries too.
The 1077 includes fitted safety terminals and is made for use with standard 4mm shrouded plugs, standard normal plugs, bare wires and spade terminals.
Includes:
Time Electronics 1077 Milliamp Transducer Simulator
Fitted Protective Cover
Installed Rechargeable Battery Pack
Mains Charger
User Manual