- Air Quality Meter
- Anemometer
- Battery Test Analyzer
- Calibration Tester
- Chart Data Recorder
- Chlorine Meter
- Clamp Meter
- Coating Thickness
- Concrete Meter
- Conductivity Meter
- Current Injection Test
- Current-Echosounder
- Deadweight Tester
- Density Meter
- Dew Point Hygrometer
- Dissolved Oxygen
- Fault Finder Locator
- Flaw Detector
- Flow Meter
- Force Gauge
- Gas Analyzer
- Gauss Meter
- Grain Moisture
- Ground Resistance
- Hand Pump
- Hardness Tester
- High Voltage Rercue
- Hipot Tester
- Holiday Detector
- Insulation Tester
- Leak Detection
- Level Lube Controller
- Light Meter
- Manometer
- Multimeter
- Networks Analyzer
- Ohm Meter
- Oil Content Analyzer
- Oscilloscopes
- Other Products
- PH Meter
- Pipe Cable Locator
- Power Quality Analyzer
- Pressure Gauge
- Rangefinder
- Shaft Alignment
- Sound Level Meter
- Spectrophotometer
- Stroboscope
- Tachometer
- Temp. Calibrator
- Thermal Imager
- Thermohygrometer
- Thermometer
- Torque Tester
- Turbidity Meter
- Ultrasonic Thickness
- Vibration Analyzer
- Video Borescope
- Water Level Meter
- Water Quality Meter
- Weather Station
- Wood Moisture Meter
HANNA HI83099 COD and Multiparameter Photometer
Harga dapat berubah sewaktu-waktu mengikuti perkembangan kurs rupiah terhadap mata uang asing lainnya sehingga sangat mungkin terjadi adanya perbedaan harga yang berlaku dengan harga yang tertera pada website kami.
This compact photometer operates in three different ranges to cover virtually every COD application: 0-150 mg/ L, 0-1500 mg/ L and 0-15000 mg/ L. The HI 83099 meets the design requirements of USEPA 410.4, guaranteeing high quality measurements suited for reporting purposes. The HI 83099 can be operated manually or from a PC via the built-in RS232 port and data can be downloaded for analysis and documented with the HI 92000 application software.
HI 83099 is one of the most versatile photometers on the market. In addition to COD, this meter measures up to 47 of the most important water quality parameters.
Runs for hours on two common 9V batteries. In addition, it can operate continuously with input voltage of 12-20 Vdc. Extremely simple to use. The front mask lists all the parameters in a numerical order and the display shows the same numbers for quick reference during testing.
This meter can be zeroed in seconds and the reagents cost much less than what you may have been used to paying.
Specifications:
Light Source : 4 tungsten lamps with narrow band interference filter 420/ 525/ 575/ 610 nm
Light Detection : 4 silicon Photocells
Power Supply : 2 x 9V battery or 12 Vdc adapter
Auto Shut-off : after 10 minutes of non-use
Environment : 0 to 50° C ( 32 to 122° F) ; RH max 95% non-condensing
Dimensions : 230 x 165 x 70 mm
Weight : 640 g

