- Air Quality Meter
- Anemometer
- Battery Test Analyzer
- Calibration Tester
- Chart Data Recorder
- Chlorine Meter
- Clamp Meter
- Coating Thickness
- Concrete Meter
- Conductivity Meter
- Current Injection Test
- Current-Echosounder
- Deadweight Tester
- Density Meter
- Dew Point Hygrometer
- Dissolved Oxygen
- Fault Finder Locator
- Flaw Detector
- Flow Meter
- Force Gauge
- Gas Analyzer
- Gauss Meter
- Grain Moisture
- Ground Resistance
- Hand Pump
- Hardness Tester
- High Voltage Rercue
- Hipot Tester
- Holiday Detector
- Insulation Tester
- Leak Detection
- Level Lube Controller
- Light Meter
- Manometer
- Multimeter
- Networks Analyzer
- Ohm Meter
- Oil Content Analyzer
- Oscilloscopes
- Other Products
- PH Meter
- Pipe Cable Locator
- Power Quality Analyzer
- Pressure Gauge
- Rangefinder
- Shaft Alignment
- Sound Level Meter
- Spectrophotometer
- Stroboscope
- Tachometer
- Temp. Calibrator
- Thermal Imager
- Thermohygrometer
- Thermometer
- Torque Tester
- Turbidity Meter
- Ultrasonic Thickness
- Vibration Analyzer
- Video Borescope
- Water Level Meter
- Water Quality Meter
- Weather Station
- Wood Moisture Meter
PCE D Shore D Portable Hardness Tester
Harga dapat berubah sewaktu-waktu mengikuti perkembangan kurs rupiah terhadap mata uang asing lainnya sehingga sangat mungkin terjadi adanya perbedaan harga yang berlaku dengan harga yang tertera pada website kami.
Hardness tester for measuring the hardness of hard rubber and hard thermal plastic
The PCE-D Hardness tester is a standard model for measuring the hardness of rubber (Shore D). The device is composed of a measurement unit with sensor and a 360° measurement dial accurate to readings of 0.5 hardness units. Meets the DIN 53505, ISO 868, ISO 7619 and ASTM D 2240 standards. The Hardness tester comes calibrated and ISO certified. The device can be recalibrated at any time with an ISO calibration certificate included (at additional cost).
Optional accessories offered for the PCE-D are a test position and a test control device to test the accuracy of the device on the job. You will always obtain the best results when measuring the hardness of rubber both in accuracy and repeatability especially when doing random testing for product control when combined with the test position.
Features:
Models with or without pulling needle
Large dial
Read in hardness units
360° dial
Highly accurate
Ergonomic design
Meets all standards
Used for isolated measurements or in series (for series measurements the optional test position is required)
Comes calibrated and ISO certified
Includes a protective cover
What's In The Box:
(1) Shore D Hardness tester PCE-D
(1) Case
(1) Calibration certificate
(1) User's manual