- Air Quality Meter
- Anemometer
- Battery Test Analyzer
- Calibration Tester
- Chart Data Recorder
- Chlorine Meter
- Clamp Meter
- Coating Thickness
- Concrete Meter
- Conductivity Meter
- Current Injection Test
- Current-Echosounder
- Deadweight Tester
- Density Meter
- Dew Point Hygrometer
- Dissolved Oxygen
- Fault Finder Locator
- Flaw Detector
- Flow Meter
- Force Gauge
- Gas Analyzer
- Gauss Meter
- Grain Moisture
- Ground Resistance
- Hand Pump
- Hardness Tester
- High Voltage Rercue
- Hipot Tester
- Holiday Detector
- Insulation Tester
- Leak Detection
- Level Lube Controller
- Light Meter
- Manometer
- Multimeter
- Networks Analyzer
- Ohm Meter
- Oil Content Analyzer
- Oscilloscopes
- Other Products
- PH Meter
- Pipe Cable Locator
- Power Quality Analyzer
- Pressure Gauge
- Rangefinder
- Shaft Alignment
- Sound Level Meter
- Spectrophotometer
- Stroboscope
- Tachometer
- Temp. Calibrator
- Thermal Imager
- Thermohygrometer
- Thermometer
- Torque Tester
- Turbidity Meter
- Ultrasonic Thickness
- Vibration Analyzer
- Video Borescope
- Water Level Meter
- Water Quality Meter
- Weather Station
- Wood Moisture Meter
TINKER & RASOR CE-IT Below Ground Insulator Tester
Harga dapat berubah sewaktu-waktu mengikuti perkembangan kurs rupiah terhadap mata uang asing lainnya sehingga sangat mungkin terjadi adanya perbedaan harga yang berlaku dengan harga yang tertera pada website kami.
The Model CE-IT Insulator Tester is a fully automatic, highly sensitive electronic instrument designed to test the effectiveness of buried pipeline insulators. The CE-IT can also be used to determine the isolation condition of pipelines in road crossing casings.
The Model CE-IT circuit automatically adjusts to the voltage polarity present on the underground piping system under test. A readout of the test results is displayed in English on the LCD meter.
GOOD: This is displayed when the Model CE-IT determines that the electrical load placed on the pipe on either side of the isolator is not leaking from one side to the other, so it is able to build a capacitive load, and therefore determines that the isolator is effective.
BAD INPUT SHORT: This is displayed when the Model CE-IT determines that the electrical load placed on the pipe on either side of the isolator is leaking from one side to the other, so it is not able to build a capacitive load, and therefore determines that the isolator is not effective.
BAD INPUT OPEN: This is displayed if the Model CE-IT is not able to electrically load one or both sides of the isolator. This result indicated a broken lead wire to one or both sides of the isolator on the pipe system under test.
The entire testing procedure is complete in less than 30 seconds, an audible signal alerts the operator when the test cycle is completed. Although the Model CE-IT is equipped with power start switch, the instrument will automatically shut off in 10 minutes if not in use, to conserve batteries.
Insulator Tester, Buried Capacitance Effect
Tests effectiveness of buried pipe insulators
Tests isolation condition of pipelines in road crossing casings
Indicates broken lead wires from test station to pipeline
Testing procedures complete in under 30 seconds
Automatic off to ensure long battery life
Factory calibrated, ready-to-use
In The Box
CE-IT Instrument, in case
9v Battery
Probe, Red with lead wires and clamps
Instruction manual
Warranty Card & Quality Statement