- Air Quality Meter
- Anemometer
- Battery Test & Analyzer
- Calibration Tester
- Chart Recorder
- Chlorine Meter
- Clamp Meter
- Coating Thickness
- Concrete Meter
- Conductivity Meter
- Current & Echosounder
- Current Injection Test
- Deadweight Tester
- Density Meter
- Dew Point Hygrometer
- Dissolved Oxygen
- Fault Finder Locator
- Flaw Detector
- Flow Meter
- Force Gauge
- Gas Analyzer
- Gauss Meter
- Grain Moisture
- Ground Resistance
- Hand Pump
- Hardness Tester
- High Voltage Rercue
- Hipot Tester
- Holiday Detector
- Insulation Tester
- Leak Detection
- Level Lube Controller
- Light Meter
- Manometer
- Multimeter
- Networks Analyzer
- Ohm Meter
- Oil Content Analyzer
- Oscilloscopes
- Other Products
- PH Meter
- Pipe Cable Locator
- Power Quality Analyzer
- Power Supply
- Pressure Gauge
- Rangefinder
- Shaft Alignment
- Sound Level Meter
- Spectrophotometer
- Stroboscope
- Tachometer
- Temp. Calibrator
- Thermal Imager
- Thermohygrometer
- Thermometer
- Torque Tester
- Turbidity Meter
- Ultrasonic Thickness
- Vibration Analyzer
- Video Borescope
- Water Level Meter
- Water Quality Meter
- Weather Station
- Wood Moisture Meter
CHAUVIN ARNOUX XA3052 Bench Power Supply
Harga dapat berubah sewaktu-waktu mengikuti perkembangan kurs rupiah terhadap mata uang asing lainnya sehingga sangat mungkin terjadi adanya perbedaan harga yang berlaku dengan harga yang tertera pada website kami.
Chauvin Arnoux XA 3052 [XA3052] 2-Output, 0 - 30V / 0 to 5 A Adjustable Bench Power Supply. The Multimetrix XA 3052 is an easy to use laboratory power supply with 2 adjustable outputs (0-30.0 V DC / 0-5.0 A DC). It is possible to connect the 2 independant outputs in parallel to obtain 60 V or 10 A. The laboratory power supply unit is therefore suitable for various applications: Laboratories, research & development, education, maintenance, etc. The voltage and current control is done with low noise. The laboratory power supply has a complete overload protection.
Part Number: XA3052
Otutputs : 2
Voltage control : Master : output 0 to 30 VDC ± 0.05% + 5 mV; Slave output 0 to 30 VDC ± 0.05% + 5 mV
Current control : Master output : 0 to 5 A ± 0.5% + 5 mA; Slave output 0 to 5 A ± 0.5% + 5 mA
2 adjustable outputs: 0-30.0 V DC / 0-5.0 A DC.
Paralleling of the 2 independent outputs to obtain 10 A.
Serialization of the 2 independent outputs to obtain 60 V.
Control of the voltage and current with low noise.
Full protection against overloads.
Include:
(1) XA3052 - Adjustable Bench Power Supply
(1) Operating manual
(2) Fuses: type T, 4 A, 250 V
(1) Mains power cable

