- Air Quality Meter
- Anemometer
- Battery Test Analyzer
- Calibration Tester
- Chart Data Recorder
- Chlorine Meter
- Clamp Meter
- Coating Thickness
- Concrete Meter
- Conductivity Meter
- Current - Echosounder
- Current Injection Test
- Deadweight Tester
- Density Meter
- Dew Point Hygrometer
- Dissolved Oxygen
- Fault Finder Locator
- Flaw Detector
- Flow Meter
- Force Gauge
- Gas Analyzer
- Gauss Meter
- Grain Moisture
- Ground Resistance
- Hand Pump
- Hardness Tester
- High Voltage Rercue
- Hipot Tester
- Holiday Detector
- Insulation Tester
- Leak Detection
- Level Lube Controller
- Light Meter
- Manometer
- Multimeter
- Networks Analyzer
- Ohm Meter
- Oil Content Analyzer
- Oscilloscopes
- Other Products
- PH Meter
- Pipe Cable Locator
- Power Quality Analyzer
- Pressure Gauge
- Rangefinder
- Shaft Alignment
- Sound Level Meter
- Spectrophotometer
- Stroboscope
- Tachometer
- Temp. Calibrator
- Thermal Imager
- Thermohygrometer
- Thermometer
- Torque Tester
- Turbidity Meter
- Ultrasonic Thickness
- Vibration Analyzer
- Video Borescope
- Water Level Meter
- Water Quality Meter
- Weather Station
- Wood Moisture Meter
MURPHY 3ST Three Point Speed Relay
Harga dapat berubah sewaktu-waktu mengikuti perkembangan kurs rupiah terhadap mata uang asing lainnya sehingga sangat mungkin terjadi adanya perbedaan harga yang berlaku dengan harga yang tertera pada website kami.
The 3ST provides three independent speed relays in one compact unit. It is designed to work with an engine mounted speed transducer, typically a magnetic pickup.The 3ST measures the transducer signal frequency (which is proportional to engine speed) and compares this with three user-set trip levels.
The three non-latching relays then activate or deactivate as appropriate.Each relay circuit has a front facia LED that lights when the relay is energised. On standard units, the relay functions are designated S1 (crank), S2 (underspeed) and S3 (overspeed): all three relays are energised, and all LEDs lit, when the engine is running at normal speed - see diagram overleaf for relay/LED operation. Nominal speed calibration and relay trip levels are set via four multi-turn potentiometers - see ‘calibration’ overleaf. The 3ST also features a ‘meter’ output, which may be used for calibration and/or engine speed indication. The 3ST has a robust, polycarbonate case, designed for DIN rail or surface mounting. Electrical connection is by 12 screw terminals, suitable for stripped panel wires or narrow blade crimps.
Application
The 3ST is designed for use with engines, generators,
pumps or any moving machinery where speed related
control that requires accurate and repeatable.
Three speed relays in one compact unit
Wide operating frequency
Engine RPM meter output