- Air Quality Meter
- Anemometer
- Battery Test & Analyzer
- Calibration Tester
- Chlorine Meter
- Clamp Meter
- Coating Thickness
- Concrete Meter
- Conductivity Meter
- Current & Echosounder
- Current Injection Test
- Deadweight Tester
- Density Meter
- Dew Point Hygrometer
- Dissolved Oxygen
- Fault Finder Locator
- Flaw Detector
- Flow Meter
- Force Gauge
- Gas Analyzer
- Gauss Meter
- Grain Moisture
- Ground Resistance
- Hand Pump
- Hardness Tester
- High Voltage Rercue
- Hipot Tester
- Holiday Detector
- Insulation Tester
- Leak Detection
- Level Lube Controller
- Light Meter
- Manometer
- Multimeter
- Networks Analyzer
- Ohm Meter
- Oil Content Analyzer
- Other Products
- PH Meter
- Pipe Cable Locator
- Power Quality Analyzer
- Pressure Gauge
- Rangefinder
- Shaft Alignment
- Sound Level Meter
- Spectrophotometer
- Stroboscope
- Tachometer
- Temp. Calibrator
- Thermal Imager
- Thermohygrometer
- Thermometer
- Torque Tester
- Turbidity Meter
- Ultrasonic Thickness
- Vibration Analyzer
- Video Borescope
- Water Level Meter
- Water Quality Meter
- Water Sampler
- Weather Station
- Wood Moisture Meter
SONEL LKZ-1000 Underground Wires and Cable Pipe Locator
Harga dapat berubah sewaktu-waktu mengikuti perkembangan kurs rupiah terhadap mata uang asing lainnya sehingga sangat mungkin terjadi adanya perbedaan harga yang berlaku dengan harga yang tertera pada website kami.
Locators are used to detect buried conductive services emitting an electromagnetic signal which is generated by a current passing through the service. Transmitters are used to apply a distinct signal to conductive services, which may not radiate electromagnetic signals or may need to be traced for a specific purpose.The Transmitter is required to make a depth measurement. The Locators and Transmitters described within this manual will greatly increase the detection process and help to reduce the dangers and costs associated with service strikes. But the very nature of electromagnetic location is dependent on the services being conductive (metallic) and radiating a signal as current flows through them. It is important to remember that a Locator on its own will not detect all services and care should be taken when excavating. It is generally accepted that a safe system of work should be adopted which would include planning the work in advance, the use of utility maps, the use of Locators and Transmitters, and the use of safe digging practices.
Features:
Backlit LCD with contrast (auto on-off),
Automatic adjustment of detection sensitivity,
5 operating modes,
Warning about shallowly located cables,
Measuring cable locations up to 3 m deep,
Determining the direction of a cable,
Sound signals to facilitate locating or tracing,
Adjustment of power and selection of frequencies for the transmitter,
Passive or active modes of tracing.
Detection of underground live wires.
Detection of underground wires with no voltage (radio mode)
Detection of underground wires with no voltage using a transmitter (galvanised, inductive or
clamp-based connection).
Tracing metallic or non-conductive pipes using an additional probe
Tracing non-conductive pipelines using a “floating” probe.
Tracing a determined cable.
Determining the depth of a cable
What's In The Box:
(1) LKO-1000 Tracer - WMPLLKO1000
(1) LKN-1000 Transmitter - WMPLLKN1000
(1) Case L6 - WAFUTL6
(1) Set of cables with "crocodile" clips - WAPRZLKZ1000
(1) Earth contact probe - WASONG15
(1) Operating manual
(10) AA Batteries